Product thermal capacity: 4-35 t/h
Working pressure: 1.0-2.5 MPA
Outlet temperature: 184-350 ℃
Available fuel: natural gas, coke oven gas, bio-gas，liquid propane gas, diesel, heavy oil, light oil, crude oil
Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries
production of sodium silicates per batch by autoclaves have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.
production of sodium silicates per batch by autoclaves.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).
1/15/2019 · 1. Introduction. Nanomaterials based on SiO 2, such as alumina-silica, magnesium-silicate and those on carbon, having morphologies of spheres, hollow spheres and nanotubes have become very important because their high specific surface areas 
The Complete Technology Book on Minerals & Mineral Processing ... As stated on the foregoing chapters, for a granite quarry having capacity production of 1500 and 2000 m3 per annum, mechanization will be required at various stages of activities like face
Both sodium silicate and silico fluoride solutions are applied to clean, dry, sound concrete floors as dilute aqueous solutions (10 to 15 per cent solids) in 2 to 3 applications, taking care to ensure that the solution penetrates and is absorbed into the
2017-7-6 · PQ sodium silicates are used in numerous mining and mineral processing systems to improve valu-able mineral recovery, while reducing unwanted contaminants. Their chief use in ore flotation is as a deflocculant for dispersing undesired clay. Sod
In a batch leaching reaction with good mixing a residence time of about 2-4 hours is suitable. If horizontal staged autoclave reactors are used the residence time may be longer, on the order of about 6-8 hours. Horizontal staged autoclaves are usually div
dehydration. Liquid sodium silicates are neutralized by sulfuric acid and the mixture is then coagulated to form hydrogel. The gel is washed to remove the sodium sulfate formed during the neutralization reaction. Then it is dried, crushed and sieved. Sphe
The soybean oil transesterification was conducted in 300 mL batch autoclave (AE – Autoclave Engineers, USA), with an electrical heater and a Rushton-type mixer (560 rpm) at the methanol to soybean oil ratio of 18:1, 448 K  and different MnCO3/Na-silic
The first liquid sodium silicate production facility in South Carolina will open in Berkeley County in the summer, bringing the raw material closer to advanced manufacturers that use it in their production. The Charleston International Manufacturing Cente
Plants for sodium silicate. Binacchi manufactures a wide choice of either static and rotating autoclaves able to satisfy any production need. In case of big productions, Binacchi can also supply the technology to produce sodium silicates starting from sil